New 3,000/6,100 Joules Surge Protection Module

Simple installation! The only tool required is a Phillips screw driver.

INSTRUCTIONS

• UNPLUG THE UNIT – make sure unit is fully disconnected from power prior to installation.

• Unscrew 8 Phillips screws on the back of the unit.

• Unscrew the top and bottom cable gland nuts.

• Unscrew the screws holding the old surge module.

• Unplug the old surge module from the unit.

• Connect the new surge protection module.

• Replace all the screws and re-tighten the cable gland nuts.

CAUTION!

Make sure unit is unplugged before installation!